ADLINK CPCI-7230 DRIVER DETAILS:
|File Size:||16.4 MB|
|Supported systems:||Windows 7/8/10, Windows XP 64-bit, Mac OS X 10.X|
|Price:||Free* (*Free Registration Required)|
ADLINK CPCI-7230 DRIVER
The card should be placed on a grounded ADLINK cPCI-7230 mat. The operator should wear an anti-static wristband, grounded at the same point as the anti-static mat.
Inspect the card module carton for obvious damage. Shipping and handling may cause damage to the module. Ensure that there are no shipping and handing damages on the module before processing. ADLINK cPCI-7230 opening the card module carton, extract the system module and place it only on a grounded anti-static surface component side up.
Again, inspect the module for damage. Press down on all socketed ICs to make sure they are properly seated.
CPCI - Adlink cPCI CH Isolated DI & CH Isolated DO Module
Do this only with the module placed ADLINK cPCI-7230 a firm flat surface. Do not apply power to the card if it has been damaged. Installation 21 2.
|Acer Aspire 3810TZG SATA||Recently Published Products:|
|Asus ZenBook 13 UX331FN Intel WLAN||Advance technologies; automate the world, Pci-/cpci-/lpci-/lpcie- 723x series, User’s manual|
|Rosewill RNWD-N1501UB USB Adapter Ralink WLAN||Photo gallery|
|Asus G55VW Notebook Intel Rapid Storage||PCI-7230/33/34|
These system resource assignments are done ADLINK cPCI-7230 a board-by-board basis. It is not recommended that the system resource be assigned by any other method.
Installation Procedures 1. Turn off the computer. Turn off all accessories printer, modem, monitor, etc. Remove the computer cover. Select ADLINK cPCI-7230 bit PCI slot. Before handling the PCI cards, discharge any static buildup on your body by touching the metal case of the computer.
Hold the edge and do not touch ADLINK cPCI-7230 components. Position the board into the selected PCI slot. Secure the card in place at the rear panel of the system. Installation 23 2. Isolated digital input channel n.
Isolated digital output channel n. ADLINK cPCI-7230 Ground or Common power of isolated input channels. Ground return path of isolated output ADLINK cPCI-7230. Power supply of isolated output channels. Common ground or common power of isolated input channels 8 to High input of isolated differential DI channel n. Low input of isolated differential DI channel n. Power input signal for fly-wheel diode of DO channels. Isolatied power output 5V. Isolated common ground. Isolated digital output signal channel n.
Isolated Ground for all isolated output channels. GND 19 Figure ADLINK cPCI-7230 Isolated ground for isolated output channels. External power supply for IDO source drivers. Available termination boards include: General-Purpose termination board with a pin D-sub male connector. This information is quite useful for programmers who wish to handle the card by low-level programming.
cPCI END OF LIFE. CH Isolated Digital I/O Module. Key Features. Two external interrupt ADLINK cPCI-7230 Isolated input voltage ADLINK cPCI-7230 to 24V; Sink current up to. Supports a bit 5 V PCI bus; CH isolated digital inputs & CH isolated digital outputs (PCI); CH isolated digital inputs (PCI); CH.